MISOLIMA eGraFIKO 640 easy
   
TFT display systems for mobile use...
    With eGraFIKO 640 is a 6.5" TFT display with integrated DOLLx8 interface, embedded keybord and options for GPS, GSM and Quad Chanal Audio System.
Embedded system
with integrated OS
and DOLLx8 software
   
 
MISOLIMA eGraFIKO 640 TFT display
Embedded VGA display with 640x480 pixels.

High performance ADC
 Fast 8 channels/10-bit ADC

Inn and Out ports (I/O Ports)
 Fast 3x 8-bit I/O Ports with independent control with settings for automatic puls down to 0.01s per channel. Built in buzzer.

Relay output
2x max 30Vdc 3A relay output

Microcontroller
 faster 18MHz Atmel microcontroller with Real Time Operating System (RTOS), 2 COM ports, Internal CompactFlash memory, DOLLx8 Network Protocol etc.

DOLLx8 and communication protocol
DOLLx8 intelligent data protocols.

PIN
PORT 1 Connector Pins
PIN
1
 Vin (Out)   GND
2
3
 Vin REL #1   Vin REL #2
4
5
 Vout REL #1   Vout REL #2
6
7
 Buzzer In (TTL)   GND
8
9
 +5V (USB)   GND
10
11
 SW #2 P1.4   SW #3 P1.5
12
eBallet ePC

PIN
PORT 2 Connector Pins
PIN
1
 Vin (Out)   GND
2
3
 ADC #2 P1.1   ADC #1 P1.0
4
5
 GND   +5V Out
6
7
 IO8 P0.7   IO7 P0.6
8
9
 IO6 P0.5   IO5 P0.4
10
11
 IO4 P0.3   IO3 P0.2
12
13
 IO2 P0.1   IO1 P0.0
14
15
 MCU Reset   GND
16
17
 ON/OFF Power   SW #3 P1.5
18
19
 SW #2 P1.4   SW #1 P1.3
20
eBallet ePC

PIN
"PC" PORT RJ-45 Connector
PIN
1
 TX DOLLx8   RX DOLLx8
2
3
 DTMF+   DTMF-
4
5
 RESERVED   GND
6
7
 +Vin (Out)   +5Vdc USB
8
eBallet ePC


MISOLIMA eBallet ePC front panel with LED indication of communication, power and I/O port status.

MISOLIMA has worked on its embedded TFT display system to ensure a rich content display system to be used in Vehicles, Marine boats and Aircraft... A real land, water and air system with plug-in options for everybody's needs, no matter if it's for taxis, trains or un-certified aircrafts.

Fast 1 GHz CPU (eBallet ePC 1500 is 1.5 GHz) for DOS, Linux, Windows or Windows XP Embedded with integrated 20 channel GPS and/or GSM as options, Embedded PS/2 Keyboard interface for soft- and hard keys, DOLLx8 3.18 network protocol, 4x4 channel Audio as option, DC-DC switching power supply plus more...

eBallet ePC from MISOLIMA is based on VIA V4 Eden/C7 processor with 4 COM ports, USB, PC-104 slot, single 5V supply (6-36V) power input, mini PCI plus more...
 o eCharlie U2R
 o eThomas REL22
 o eOscar KeyPad
 o eAlbert DOLLx8
 o eBonnie 15-368 AVL
 o eClyde 15-368 GSM
 o ePAT MCU
 o eGSM Q4 1800
 o eLeon Horizon60
 o eMichael MiRAS
 o eJames GPS III
 
 o eMessanger 220
 o eBalletPC
 o eGraFIKO 640 TFT
 

 Company: MISOLIMA
 Product ID: 002A11XXX
 DOLLx8 Ver.: 3.0r18
 HWUART Baudrate: 38400
 Device: eBallet PC 1000
 Hardware Ver.: 1.0r02
 Embedded Software Ver.: 1.0r01
 Software Date: 20 OCT 2011
 MCU Speed: 18.432 MHz
 

GSM/GPS AVL tracking

In today's market situation, keeping track of vehicles positioning via GSM/GPS technologies has never been easier. Thanks to MISOLIMA eBonnie and eClyde 15-368 AVL, a global positioning satellite fleet management system, you are now able to track and manage not only the vehicles but also combine AVL with I/O devices, sencors, relays as well as multimedia audio, all managed over a single text-based bus protocol named DOLLx8.

Driver available for download and set-up on most Windows® operating systems.
Features
• Built in high power DC-DC switching powersupply (6 to 28VDC input)
• VIA V4 compliant Eden/C7 processor onboard with FSB 400/533 MHz
• Uses Quad-band GSM module
• Uses SiRF StarIII GPS receiver
• Uses DOLLx8 network and data protocol
• Has integrated Buzzer functions
• DualView with different content & resolution
• 4 COM and 4 USB 2.0 ports
• PC/104 and MiniPCI slots for expansion
• Analog to Digital converter
• Built-in relays
• SMA GSM and GPS connector
• LED indication on front pannel
• Colours: Red, Purple, Blue and Black
• Dimensions: D104mm, W146mm, H50mm
                     (D4.09", W5.74", H1.96")


CPU Ultra low power VIA V4 Eden/C7 processor (EBGA packaging) CPU - 1 GHz (800 MHz as option)
Chipset VIA CX700M
I/O Chipset Built-in VT82C686B
BIOS Phoenix-Award® 256KB Flash BIOS
Memory 1 x 200-pin SO-DIMM supports DDR2-400/533 max. up to 1GB
Enhanced IDE Support two IDE devices, Shared with SSD. Support Ultra DMA 33/66/100 mode with data transfer rate up to 100MB/sec
FDD interface Support one 3.5" floppy disk drives
Parallel port One bi-directional parallel port. Support SPP, ECP, and EPP modes
Serial port Four RS-232 serial ports
USB 4x USB 2.0 ports
KB/Mouse connector Connector on board support PC/AT keyboard and PS/2 mouse - support multiple keboards to one port via the keyboard interface.
Integrated DC-DC switching power supply 6-36 V DC input range (embedded)
Battery Lithium battery for data retention up to 10 years (in normal condition)
Watchdog Timer Can generate a system reset, or IRQ11. Support software selectable timeout interval
Digital I/O Eight digital output and eight input
PC/104 Connector One PC/104 connector for ISA expansion board
Flat Panel/CRT Interface Support CRT, 18-bit TFT LCD & LVDS panel interface. DualView with different content & resolution
Display memory Max. up to 128 MB
Resolution Flat panel displays support up to 1024 x 768 @ 18bpp TFT panel and CRT monitors up to 1024 x 768 @ 16bpp or 1280 x1024 @ 8bpp
GPS (option) Embedded 20 channels SiRF StartIII as option
Audio (option) Embedded 16-bit Stereo with eMichael MiRAS chipset 4x4 audio channels audio processor as option
GSM (option) Embedded Quad-band GSM as option
Keyboard Interface 1 x PS/2 keyboard and mouse
4x4 matrix keyboard interface (16 keys) w/LED DIM function, FAN and temperature control.
Audio HD Codec audio as MIC-in/Line-in/Line-out/speaker-out with VIA VT1708B
Network DOLLx8 3.18 network Protocol for sensor, switches and communication data management.
Ethernet chipset One Intel 82559ER 100Base-Tx Fast Ethernet controller
Ethernet interface 1 port as 10/100Mbps supports Wake-on-LAN,
RPL/PXE Boot ROM with Realtek RTL8139DL
SSD Interface 1 x CompactFlash™ type-II
Internal Power supply voltage +5VDC (4.75V to 5.25V)
Max. power requirements 2.6A @ 5 V
Operating temperature 32 to 140°F (0 to 60°C)
Board size 146mmx104mm
Weight 0.26 lb. (0.12 Kg) (bare)
Estimated R.R.P CALL

How does DOLLx8 work?

DOLLx8 stands for Digital One Line Link and it is well known that if your devices can do more things, you can also do more things with it. Check out how the easy to use and easy to program or control capabilities of DOLLx8 Certified devices can revolutionize the way you control your electrical devices at home, office, workplace or in vehicles. As embedded system DOLLx8 Certified devices can be controlled via RS-232, USB or GSM with easy to use text messages.

All you need to get started is one or more DOLLx8 Certified devices that links to each other with standard PC network cable with RJ-45 connectors. All is made easy because DOLLx8 Certified devices are able to connect, discover and communicate with each other over a DOLLx8 Certified network – that again might connect to one or more PC's for I/O control. In fact more than one PC can share the control of the DOLLx8 Certified devices that might also carry Username and Password functions for security reasons.

My page history: PatMCU | Michael | Projects01 | CharlieU2R | AlbertMore | Clear History
 
MISOLIMA 
www.misolima.com and its brand MISOLIMA© is licensed 
Copyright® 2000/11 - All rights reserved. 
Privacy Policy | Return Policy | Terms and Conditions | Terms and Conditions |
Note: All the dates (DD.MM.YY) and times are given in Far East Time (UTC+07:00)